Leitkiel FS Slot.it with srew

Details
Customer-tip

1 piece Leitkiel with mounting screw and washer

This guide keel has an optimized geometry at Leitkielschwert and is designed specifically for the Carrera track.

Not suitable for Ninco tracks.

The sword is deeper and wider than the Slotit Kiel, thereby setting the course in digital mode are switched clean and improves the guidance in the curves

Polyamide with fiberglass, weight 0.70 grams

Sword depth 6.9 mm, 3.60 mm shaft diameter, total length about 22.5 mm

This guide keel is for the new generation of chassis Slotit!

Old Chassis have a receptacle height of 4.8 mm. The new chassis CS03T60B for all P956 / 962 has been at the receiving a height of 5.1 mm, also the hole is smaller with 3.70 mm.

For a proper fit / guide the guide keel must briefly abfeilen with a file this 0.3 mm with the old chassis, so that by means of the screw an ideal match can be set.

In addition, we have found in tests that are in other types of chassis where Leitkiele installed with clip function above in the recording there is a burr (eg GT 40). This burr must be removed, so that the guide keel rotates clean.

Other chassis have below a ridge in the receiving bore. Easily the Leitkiel only from above plugged move, the burr is below. Thus, it must be broken edge of the mounting side short with a scalpel or cutter.

With new chassis from 2015 no adjustment is required Gerell!