Slotlight1 light kit warm/white Brake + exhaust

Description and content:

Slotcar permanent lighting - Remnants
Warning magnet wire must be soldered to the board! Pull the enameled wire through the hole on the board, scrape with a model knife or other goods under the paint from the wire end, wire and solder tin PCB, wire as far from the board retreat that the bare spot is located at the solder, solder grants.
Who does the soldering can not should prefer to buy the new version!

Slotcard Auer Lighting - Novelty
all solder joints are on the outside of the module and provided with bore, thus an easier connection of the enameled wire möglich.Platine 30x12x1mm, about 3 g with gold cap.
The module should be placed as close to the middle and deep to the chassis (weight shift)
Connections Slotlight 1:
Plus and Minus
Tail light with integrated. brake light
Rear light with separate brake light
brake light
front light
Interior light / position light e.g. at LM 24h race
exhaust flames
The set consists of:
2 x SMD LED red tail light assy. Leaded with colored copper wire 0.19 m ²
2 x SMD LED red stop light, assy. Leaded with colored copper wire
2 x SMD LED Xenon headlight, assy. Leaded with colored copper wire
1 x SMD LED blue light inside, compl. Leaded with colored copper wire
(Connection can also be used for position light)
2 x LED 2mm exhaust flames, not wired!
(The accessory fitting tailpipes)
1 x board 30 x 12 x 1mm, SMD both sides equipped with aufgelöt. goldcap
(The accessories: 3-wire colored micro plug set with cable)
 
 
- Antistatic packaging, including wiring diagram,
- The lighting module is manufactured in Germany!
-the set is designed 6-20 volts tension

The LEDs still light up until the ELKO is empty.