Article: Slot Racing vehicle
Scale: 1/32
Manufacturer: RevoSlot
Scope of delivery: ready-to-run (RTR) finished model completely pre-assembled
Compatibility: Runs on all car racing tracks with rails in 1/32 and 1/24 scale according to the international standard
Operating System: International (Analog)
Operating voltage: 9 to 15 volts DC
Body: hard plastic
Chassis: Aluminum two-piece
Suspension magnet: Yes (optional mountable)
Engine: RevoSlot type RS 21k
Engine holder: Anglewinder
Drive: rear-wheel drive
Gearbox: Motor 12 teeth / axis 33 teeth with set screw M3
Axles front / rear: blank axles Ø3mm
Rims front / rear: aluminum with adjusting screw M3
Tire front / rear: solid rubber
Highlights:
Lightweight cockpit
Optional racing guide keel especially for lanes with a deep slot
Vehicle optionally mobile with or without keel suspension
Mobile landing gear
Ball bearings on the front and rear axles
Separate axle holders front and rear
Separate motor holder
Hints:
Due to true-to-original model design not to drive on special lanes such as off-road or obstacle routes, strong shaped crossings, tight banked curves and the like. suitable. Suspension magnet adhesion effect works on all webs with magnetic traction power conductors. Chassis prepared for decoder installation for digital operation.
Danger! Not suitable for children under 14 years.
Write the first Review!
This Product was added to our catalogue on 27/04/2022.